Maldet setup cron

1. Install 'ed': You can install 'ed' using the yum package manager on CentOS. Run the following command as root or with sudo:

 

1. Check PATH environment variable: Verify that the directory containing the 'ed' binary is included in the PATH environment variable. You can check the current PATH variable by running the following command:

 Make sure the directory containing the 'ed' binary (usually /bin) is listed in the PATH. If it is not, you can add it to the PATH by modifying the /etc/environment file or by adding the following line to your shell profile file (e.g., ~/.bashrc or ~/.bash_profile):
 Note: The location of the 'ed' binary may vary depending on your system configuration. You can use the 'which' command to find the exact path of the 'ed' binary, for example:
 

1. Restart Maldet: After installing 'ed' and updating the PATH variable, try restarting Maldet using the following command:

 

1. Verify Maldet: You can verify if Maldet is running without any errors by checking its status using the following command:

If Maldet starts successfully without any error messages, then the issue should be resolved.If the issue persists, you may need to check the Maldet configuration file (/usr/local/maldetect/conf.maldet) and ensure that the path to 'ed' is correctly configured.By following these steps, you should be able to fix the "could not find monitor mode dependency 'ed' in PATH" error and start Maldet successfully on CentOS.
 

Παρακαλούμε συνδεθείτε για να δείτε τις απαντήσεις

Παρακαλούμε συνδεθείτε για να δείτε τις απαντήσεις